Page 1 of 1

iOptron CEM40

Posted: Mon May 13, 2019 1:41 pm
by Voyageur
Do any of you have this *quite new* mount? It was introduced at NEAF a month or so ago, and is now on backorder at all iOptron retailers. I have asked two retailers, by email, what the status of these mounts is and how one would back order one, if one wanted to, and nobody has replied. Perhaps there is a huge interest and they don't want anyone else on the list because they know they are not going to be able to fulfill existing backorders for a long time. Who knows?

I don't know for sure that I want one, but would like to learn more about it. A strong appeal for me is the relative light weight of the mount for its stated load capacity. This may be the year I get started with AP; I've been researching and reading and thinking for almost 3 years. Had fun with phone photos this winter, and think I might want to dip another toe into the muck.

I also like the looks of it. ;)

Re: iOptron CEM40

Posted: Mon May 13, 2019 5:06 pm
by STEVE333
Hi Voyageur - I have just received my CEM40 EC and am in the process of getting it "setup" (Zero marks, etc.). I purchased mine from Woodland Hills Camera & Telescope at www.Telescopes.net . I have found them easy to work with and knowledgeable. Unfortunately the power supply just died, so, dead in the water till I get a replacement. I will post a mini-review when it is up and running in this sub-forum. I will say I'm excited about their cable handling features which allow the cables to go down through the center of the mount under the dovetail slide. Should make balancing easier. We shall see!

Steve

Re: iOptron CEM40

Posted: Wed May 15, 2019 3:42 am
by Voyageur
Thanks, Steve! I eagerly await your review. Sorry about your power supply.

Re: iOptron CEM40

Posted: Fri May 17, 2019 3:07 am
by STEVE333
Just a quick update.

A new power supply just arrived today and works fine. No charge of course.
When I tried to connect to the mount's iPolar system (their version of Pole Master, but, easier and faster to use than Pole Master) with my older laptop which I use to control the DSLR camera as well as the guiding with an Orion MMAG guide system and PHD2, it didn't work. At first I thought it was iPolar, but, it turned out to be my "flaky" older laptop. Just purchased a used laptop and now the connection works fine.

Can't try anything out because, of course, the rain arrived within a day of when the UPS truck delivered the new mount.

More to come.

Steve

Re: iOptron CEM40

Posted: Fri May 24, 2019 7:03 pm
by STEVE333
Just FYI - The first part of the review is now posted.

Steve