Any pre-testing ideas or comments are welcome...
Thank you.....Dan
If and when you do this, be careful! My meat paws, hands, scratched a $370 flattener when trying to tighten the retaining ring after it had worked loose and was causing some tilt in my images.Lady Fraktor wrote: ↑Tue Dec 13, 2022 4:53 am It should not be a issue, look close at the ring holding the glass. Are there a couple of small notches in it?
If so use a small thin flat blade screwdriver and give it a gentle nudge/ push clockwise. The ring should tighten a bit and get rid of the rattle.
If there is no retaining ring then there will not be much that you can do but the filter should work fine anyways.
What type of filter is it?
You need to be a member in order to post a reply
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute