Different collimation for f/5 and lower newt?
- StarLord101
- Moon Ambassador
- Articles: 0
- Posts: 95
- Joined: Sat Apr 25, 2020 10:52 pm
- 4
- Location: North Vancouver, BC, Canada
- Status:
Offline
Different collimation for f/5 and lower newt?
I picked up an avx mount with the six inch celestron Newtonian reflector. I've done collimation before but it's been years, so I read some guides watched some videos for a refresher. Came across a few mentions that fast news f/ 5 and lower, you actually don't have everything all centered when it's properly collimated. I see a few examples that show what looks to me like a very non collimated state with some things centered and others offset. My issue is that with collimation, you have this target. It's correct when everything is round and centered. With that caveat though, I have no idea how to tell what my target is since I'm not necessarily trying to get something in a center mark. I could not find any clarification other than an aside like " oh by the way, fast will look more like this"
LXD75 GEM mount used with 90mm Meade Refractor, 102mm Celestron reflector, and a deforked Original Meade ETX Mak
Canon T1i stock
Various modified or 3d printed DIY enhancements or tweaks
Does a kids sunglass lens count as a fancy filter? Cause I have lots of those
Canon T1i stock
Various modified or 3d printed DIY enhancements or tweaks
Does a kids sunglass lens count as a fancy filter? Cause I have lots of those
- notFritzArgelander
- In Memory
- Articles: 0
- Posts: 14925
- Joined: Fri May 10, 2019 4:13 pm
- 4
- Location: Idaho US
- Status:
Offline
-
TSS Awards Badges
Re: Different collimation for f/5 and lower newt?
I don't understand the situation you describe..... I've rolled my own Newtonian, a slow one, and have had f4, f5, and f6 scopes. Aside from the question of whether an offset is necessary for the secondary flat I'm not sure what the issue might be. If you could post a link to the collimation advice you refer to in your post, it would help us answer you better?
Scopes: Refs: Orion ST80, SV 80EDA f7, TS 102ED f11 Newts: AWB 130mm, f5, Z12 f5; Cats: VMC110L, Intes MK66,VMC200L f9.75 EPs: KK Fujiyama Orthoscopics, 2x Vixen NPLs (40-6mm) and BCOs, Baader Mark IV zooms, TV Panoptics, Delos, Plossl 32-8mm. Mixed brand Masuyama/Astroplans Binoculars: Nikon Aculon 10x50, Celestron 15x70, Baader Maxbright. Mounts: Star Seeker IV, Vixen Porta II, Celestron CG5
- John Baars
- Co-Administrator
- Articles: 5
- Posts: 2749
- Joined: Sat May 11, 2019 9:00 am
- 4
- Location: Schiedam, Netherlands
- Status:
Offline
-
TSS Photo of the Day
TSS Awards Badges
Re: Different collimation for f/5 and lower newt?
If you meant if an offset is necessary, the answer is yes. See post 4 in this link: https://www.cloudynights.com/topic/5266 ... al-offset/
Refractors in frequency of use : *SW Evostar 120ED F/7.5 (all round ), * Vixen 102ED F/9 (vintage), both on Vixen GPDX.
GrabnGo on Alt/AZ : *SW Startravel 102 F/5 refractor( widefield, Sun, push-to), *OMC140 Maksutov F/14.3 ( planets).
Most used Eyepieces: *Panoptic 24, *Morpheus 14, *Leica ASPH zoom, *Zeiss barlow, *Pentax XO5.
Commonly used bino's : *Jena 10X50 , * Canon 10X30 IS, *Swarovski Habicht 7X42, * Celestron 15X70, *Kasai 2.3X40
Rijswijk Public Observatory: * Astro-Physics Starfire 130 f/8, * 6 inch Newton, * C9.25, * Meade 14 inch LX600 ACF, *Lunt.
Amateur astronomer since 1970.
GrabnGo on Alt/AZ : *SW Startravel 102 F/5 refractor( widefield, Sun, push-to), *OMC140 Maksutov F/14.3 ( planets).
Most used Eyepieces: *Panoptic 24, *Morpheus 14, *Leica ASPH zoom, *Zeiss barlow, *Pentax XO5.
Commonly used bino's : *Jena 10X50 , * Canon 10X30 IS, *Swarovski Habicht 7X42, * Celestron 15X70, *Kasai 2.3X40
Rijswijk Public Observatory: * Astro-Physics Starfire 130 f/8, * 6 inch Newton, * C9.25, * Meade 14 inch LX600 ACF, *Lunt.
Amateur astronomer since 1970.
- Lady Fraktor
- Universal Ambassador
- Articles: 0
- Posts: 9992
- Joined: Mon Apr 29, 2019 9:14 pm
- 4
- Location: Slovakia
- Status:
Offline
Re: Different collimation for f/5 and lower newt?
You center everything while collimating, what it looks like after collimation is no concern.
Sometimes the secondary will seem to be offset more so if a spherical mirror but nothing to worry about.
Read the Astro Baby Collimation Guide, honestly the last place I go for good advice is youtube...
Sometimes the secondary will seem to be offset more so if a spherical mirror but nothing to worry about.
Read the Astro Baby Collimation Guide, honestly the last place I go for good advice is youtube...
Gabrielle
See Far Sticks: Elita 103/1575, AOM FLT 105/1000, Bresser 127/1200 BV, Nočný stopár 152/1200, Vyrobené doma 70/700, Stellarvue NHNG DX 80/552, TAL RS 100/1000, Vixen SD115s/885
EQ: TAL MT-1, Vixen SXP, SXP2, AXJ, AXD
Az/Alt: AYO Digi II, Stellarvue M2C, Argo Navis encoders on both
Tripods: Berlebach Planet (2), Uni 28 Astro, Report 372, TAL factory maple, Vixen ASG-CB90, Vixen AXD-TR102
Diagonals: Astro-Physics, Baader Amici, Baader Herschel, iStar Blue, Stellarvue DX, Tak prism, TAL, Vixen
Eyepieces: Antares to Zeiss (1011110)
The only culture I have is from yogurt
See Far Sticks: Elita 103/1575, AOM FLT 105/1000, Bresser 127/1200 BV, Nočný stopár 152/1200, Vyrobené doma 70/700, Stellarvue NHNG DX 80/552, TAL RS 100/1000, Vixen SD115s/885
EQ: TAL MT-1, Vixen SXP, SXP2, AXJ, AXD
Az/Alt: AYO Digi II, Stellarvue M2C, Argo Navis encoders on both
Tripods: Berlebach Planet (2), Uni 28 Astro, Report 372, TAL factory maple, Vixen ASG-CB90, Vixen AXD-TR102
Diagonals: Astro-Physics, Baader Amici, Baader Herschel, iStar Blue, Stellarvue DX, Tak prism, TAL, Vixen
Eyepieces: Antares to Zeiss (1011110)
The only culture I have is from yogurt
- yobbo89
- Moderator
- Articles: 0
- Posts: 2593
- Joined: Sat May 11, 2019 7:44 pm
- 4
- Location: australia qld brisbane
- Status:
Offline
-
TSS Photo of the Day
Re: Different collimation for f/5 and lower newt?
Only the secondary is offset in the secondary holder and there is a good reason for that, collimation is as usually as for any other Newtonian in the same/simular design.
As show in the image below fig b. , when one is using a centered secondary part of the light cone misses the secondary due to the angle of the fast primary and in general cutting across downwards on a triangle actually slices through a thicker portion while cutting on an angle away slices through a thiner portion,
Fig a is the correct mirror offset and fig c is somewhat doable that you can actually collimate a fast scope with a centered secondary but you would need to tilt the focuser after to avoid of axis tilt.
In addition you will find that visual scopes will have a smaller secondary as full illumination isn't as much in favour visual over imaging and that less obstruction is more ideal which gives you better contrast while viewing and also that the focal point is alot shorter for eyepieces so the fold of the light cone can be made higher towards the apex.
As show in the image below fig b. , when one is using a centered secondary part of the light cone misses the secondary due to the angle of the fast primary and in general cutting across downwards on a triangle actually slices through a thicker portion while cutting on an angle away slices through a thiner portion,
Fig a is the correct mirror offset and fig c is somewhat doable that you can actually collimate a fast scope with a centered secondary but you would need to tilt the focuser after to avoid of axis tilt.
In addition you will find that visual scopes will have a smaller secondary as full illumination isn't as much in favour visual over imaging and that less obstruction is more ideal which gives you better contrast while viewing and also that the focal point is alot shorter for eyepieces so the fold of the light cone can be made higher towards the apex.
scopes :gso/bintel f4 12"truss tube, bresser messier ar127s /skywatcher 10'' dob,meade 12'' f10 lx200 sct
cameras : asi 1600mm-c/asi1600mm-c,asi120mc,prostar lp guidecam, nikkon d60, sony a7,asi 290 mm
mounts : eq6 pro/eq8/mesu 200 v2
filters : 2'' astronomik lp/badder lrgb h-a,sII,oIII,h-b,Baader Solar Continuum, chroma 3nm ha,sii,oiii,nii,rgb,lowglow,uv/ir,Thousand Oaks Solar Filter,1.25'' #47 violet,pro planet 742 ir,pro planet 807 ir,pro planet 642 bp ir.
extras : skywatcher f4 aplanatic cc, Baader MPCC MKIII Coma Corrector,Orion Field Flattener,zwo 1.25''adc.starlight maxi 2" 9x filter wheel,tele vue 2x barlow .
cameras : asi 1600mm-c/asi1600mm-c,asi120mc,prostar lp guidecam, nikkon d60, sony a7,asi 290 mm
mounts : eq6 pro/eq8/mesu 200 v2
filters : 2'' astronomik lp/badder lrgb h-a,sII,oIII,h-b,Baader Solar Continuum, chroma 3nm ha,sii,oiii,nii,rgb,lowglow,uv/ir,Thousand Oaks Solar Filter,1.25'' #47 violet,pro planet 742 ir,pro planet 807 ir,pro planet 642 bp ir.
extras : skywatcher f4 aplanatic cc, Baader MPCC MKIII Coma Corrector,Orion Field Flattener,zwo 1.25''adc.starlight maxi 2" 9x filter wheel,tele vue 2x barlow .
- Piet Le Roux
- Jupiter Ambassador
- Articles: 0
- Posts: 284
- Joined: Mon May 13, 2019 6:33 pm
- 4
- Location: Bloemfontein, South Africa
- Status:
Offline
-
TSS Photo of the Day
Re: Different collimation for f/5 and lower newt?
When I did my first collimation with a short focal length F6 telescope this "centered" misinformation gave me a lot of headache! The important thing that the "experts" and collimation manual should say is : No collimated reflector does appear completely "centred" then looking down a Cheshire Collimating Eyepiece.....it is just more apparent when this is done with a fast reflector.StarLord101 wrote: ↑Thu Jun 04, 2020 9:18 pm I picked up an avx mount with the six inch celestron Newtonian reflector. I've done collimation before but it's been years, so I read some guides watched some videos for a refresher. Came across a few mentions that fast news f/5 and lower, you actually don't have everything all centered when it's properly collimated. I see a few examples that show what looks to me like a very non collimated state with some things centered and others offset. My issue is that with collimation, you have this target. It's correct when everything is round and centered. With that caveat though, I have no idea how to tell what my target is since I'm not necessarily trying to get something in a center mark. I could not find any clarification other than an aside like " oh by the way, fast will look more like this"
Here is a example of collimator instructions :
Here is a example of A perfectly aligned Newtonian telescope with focal ratio about 1.75. Displaying centered and
non-centered features: The reason is that the oval shape secondary mirror is "distorted" by 45 degrees so that it appears to be round when looking down the focuser tube. The centre of the image is not the centre of the mirror when looking at it at a zero degrees.
Main Equipment : Tele Vue 27mm Panoptic, 7&13mm Nagler, Big Barlow : 8" Meade LX90ACF with Meade 2.0" Enhanced Diagonal : Camera Fuji XT100
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute