It was missing the drive motors, controller, eyepiece tray, and finder scope as well as all the eyepieces.
The motors were a problem only because the
The hold up at the moment is the focuser and eyepieces.
This is set up for the obsolete 0.965" eyepieces which I don't want to waste money on. All of my other gear is 1.25".
The eyepiece holder is threaded onto the drawtube which is just over 2" in dia. It comes off pretty easily.
So my options are to try and find a part that will thread on to the existing focuser or replace the whole thing. The later will probably involve drilling holes in the
Other options? Suggestions?