The method originates from the old days. In those days I had no apps or polar finder. Just a map of the environment of Polaris.
1. Take care that your finder is good aligned with your telescope
2. Put the mount in the park position. With the counterweights down and your latitude scale in the right reading of your location.
3. Put Polaris in the finder, while using Altitude and Azimuth knobs only.
4. Look in the main scope with your lowest magnification, Polaris should be in the center. Prism or no prism, no problem. Field of view in my case was 0,8 degrees, roughly as much as the yellow circle in the image. Having a field of 1,2 degrees is more than enough.
Now it really starts. 6. Look for the star pattern that is shown in the pic. It should be in the same field. The stars are connected with a yellow line in the image. This is a bit harder than it seems. It is quite easy to take by mistake almost the same star pattern as shown in another corner. ( here left and up)
7. Note that star Mv8.1 and Mv10.4 in the pic are 13 arc minutes separated, and the true North pole is another 13 arc minutes away. Those two stars show you the way. I drew an imaginary red triangle just for help. 8. Put the estimated spot in the middle of your field of view by turning the altitude and azimuth knobs of you mount. Stay away from
9. Bob's your uncle. The true pole is less than 2 arc minutes away, more accurate than usual every day polar finders. Checking with star-drifting at 400X resulted in a drift of a few arc-seconds / time-minute.
10. If necessary you can complete this alignment with the star-drifting method for photography. But that is another cup of tea.