Come join the friendliest, most engaging and inclusive astronomy forum geared for beginners and advanced telescope users, astrophotography devotees, plus check out our "Astro" goods vendors.
Come join the friendliest, most engaging and inclusive astronomy forum geared for beginners and advanced telescope users, astrophotography devotees, plus check out our "Astro" goods vendors.
New to astrophotography. I have a new (2 months old) EQ6-R PRO and I cannot get APT to connect. Well, maybe and maybe not. When I connect, the RA and DEC numbers on APT are changing, but the directional buttons for slewing the mount get no response. I have just about used YouTube up trying to solve this problem.
My mount has the USB B port on the the mount (everything I have found so far assumes the older serial plug).
I'm using a new, fast laptop with Windows 10 64 bit.
My SynScan is Version 04.39.04 and the hand controller has a USB B port on it as well.
When I control the mount from the PC using the SynScan program, everything connects and works.
When APT is displaying RA and DEC numbers, they are not the same as displayed on the hand control. APT connects correctly with my ZWO 294 MC as well as my Canon 80D.
i would try other software if you can't get it working, just to see if the mount is talking to the laptop. dealing with usb port is a little different on my end,i have an old eq6 with com port. is there eqmod support for the new eq6 ? i use this and stellarium scope .
scopes :gso/bintel f4 12"truss tube, bresser messier ar127s /skywatcher 10'' dob,meade 12'' f10 lx200 sct
cameras : asi 1600mm-c/asi1600mm-c,asi120mc,prostar lp guidecam, nikkon d60, sony a7,asi 290 mm
mounts : eq6 pro/eq8/mesu 200 v2
filters : 2'' astronomik lp/badder lrgb h-a,sII,oIII,h-b,Baader Solar Continuum, chroma 3nm ha,sii,oiii,nii,rgb,lowglow,uv/ir,Thousand Oaks Solar Filter,1.25'' #47 violet,pro planet 742 ir,pro planet 807 ir,pro planet 642 bp ir.
extras : skywatcher f4 aplanatic cc, Baader MPCC MKIII Coma Corrector,Orion Field Flattener,zwo 1.25''adc.starlight maxi 2" 9x filter wheel,tele vue 2x barlow .
Are you using the ASCOM drivers to connect your mount to any software you are using? If not, they are free and I highly recommend you download and install them.
Thanks to both for your response. I got it working tonight. I access the mount with EQMOD and then APT connects and controls. Yes, I already had ASCOM loaded...thanks.