I managed to convert from normal to modded. I did some
Total failure. The glass epoxied over the sensor was harder to remove than anticipated. Commercially, they remove it with some nasty chemicals. I was not interested in exposing myself to any HF acid... so I tried to cut the glass (first pix) and then break it.
So I broke the glass -- and it did not break according to plan... To put it mildly. NOT a clean break. Anyway, after I broke the glass cover and turned on the camera: this is what I saw on the LCD screen and this is a picture of a soapstone table ornament (with a carved giraffe showing):
I knew I was in trouble. The camera would power on, but the sensor was already damaged. That was BEFORE attempting to remove the CFA on the sensor.
Having already bungled the project (probably inevitable given the procedure I was using), I proceeded to try and scrap off some of the CFA. That just made matters worse.
The following is a picture of a set of camera lenses (only one appears on the right of the image because the left side of the sensor is damaged beyond repair).
BABO