SOOOOOO....being the ingenious person I am...I sort of figured the 10" and the 8" are basically the same with just the longer rod holding the weights.
Figured I might be able to shorten the rod using a dremel tool and make it work with the 8"
Bought the 10" system and you can see in the pics it is quite a bit longer on the 8"
Started by cutting the rod to length.
Then notched it out for the screw.
Installed on the
I lost the tapped hole for the end rod screw to keep the weights from sliding off, not a big deal, figured I'd install a hitch pin clip. A little paint and it will look just fine!!!
Pics seem to have loaded backwards......